Phone · Motorola · G200 5G
Motorola G200 5G Speaker Repair
Speaker Repair guide for the Motorola G200 5G
Before you begin
Tools
- Heat gun or hair dryer
- Suction cup tool
- Plastic opening pick
- Phillips #000 screwdriver
- Spudger tool
- Tweezers
- SIM eject tool
Parts / materials
- Replacement Motorola G200 5G loudspeaker module
- Pre-cut back cover adhesive tape
- Isopropyl alcohol (99%)
Safety
- Wear safety glasses to protect your eyes when prying glued plastic parts.
- Ensure the phone is completely powered off before starting internal disassembly.
- Use isopropyl alcohol in a well-ventilated area away from open flames.
Overview
Step-by-step
- 1
Power off device
1 minPress and hold the power button, then select Power Off on the screen to shut down the phone completely.
- 2
Eject SIM card tray
1 minInsert a SIM eject tool into the hole at the bottom left of the phone and push inward to eject the tray.
- 3
Heat back cover edges
2 minUse a heat gun or hair dryer on low heat to warm all four edges of the back cover for about two minutes.
- 4
Apply suction cup
1 minPlace a suction cup near the bottom edge of the rear panel and pull up gently to create a slight gap.
- 5
Insert plastic opening pick
1 minSlide a thin plastic opening pick into the gap between the plastic back cover and the frame.
- 6
Slice rear adhesive
3 minGently slide the pick along all edges of the phone to cut through the adhesive seal.
- 7
Remove back cover
1 minCarefully lift the back cover straight off the chassis and set it aside on a clean surface.
- 8
Unscrew lower speaker assembly
2 minUse a Phillips #000 screwdriver to remove all screws securing the lower loudspeaker housing.
- 9
Pry up loudspeaker module
2 minInsert the flat end of a spudger under the notch of the speaker housing and gently pry it up.
- 10
Remove old loudspeaker
1 minLift the original loudspeaker module out of the lower recess using tweezers.
- 11
Clean speaker recess
2 minWipe down the speaker contact pads and housing cavity using isopropyl alcohol and a lint-free cloth.
- 12
Insert new loudspeaker
2 minPlace the new loudspeaker module into the lower cavity, aligning the golden spring contacts properly.
- 13
Secure speaker housing screws
2 minReinstall and tighten all Phillips #000 screws on the loudspeaker module until snug.
- 14
Apply new cover adhesive
3 minApply pre-cut adhesive tape along the perimeter of the phone frame.
- 15
Seal back cover
2 minAlign the back cover over the frame and press firmly around all edges to secure it in place.
After your Motorola G200 5G speaker repair
Power the G200 5G back on and test the speaker repair function before you put every screw away. Check touch/display response, charging, cameras, buttons, and wireless as relevant to this repair. If something fails after closing the device, reopen carefully and reseat the connectors for this Motorola G200 5G job before assuming the part is defective. Keep leftover adhesive and screws labeled in case you need a second pass.
Keep learning
Explore more Motorola G200 5G repair context in the encyclopedia, or open related DIY guides.
