Phone · Motorola · G200 5G
Motorola G200 5G Logic Board Repair
Logic Board Repair guide for the Motorola G200 5G
Before you begin
Tools
- Heat gun or hair dryer
- Phillips #000 screwdriver
- Plastic opening picks
- Suction cup tool
- Plastic spudger
- Tweezers
- SIM card eject tool
Parts / materials
- Pre-cut back cover adhesive
- 99% Isopropyl alcohol
Safety
- Wear safety glasses while applying heat to plastic panels.
- Disconnect the battery press connector immediately after opening to eliminate electrical risk.
- Do not puncture, squeeze, or apply leverage to the lithium battery.
Overview
Step-by-step
- 1
Eject SIM Card Tray
1 minInsert a SIM eject tool into the hole beside the SIM tray at the bottom edge. Press firmly to pop out and remove the SIM tray.
- 2
Heat Back Cover
2 minApply a heat gun on low heat around the outer edges of the back panel for two minutes to soften the adhesive seal.
- 3
Attach Suction Cup
1 minPlace a suction cup on the lower portion of the back panel and pull upward gently to create a slight gap.
- 4
Slice Rear Adhesive
4 minInsert a plastic opening pick into the gap and slide it along the perimeter to cut through the adhesive.
- 5
Remove Back Panel
1 minLift the plastic back panel completely off the phone frame and place it on a clean surface.
- 6
Unscrew Top Shield
3 minUse a Phillips #000 screwdriver to remove all screws holding the top motherboard plastic cover in place.
- 7
Detach Top Shield
1 minInsert the flat end of a spudger beneath the motherboard shield and lift it off the chassis.
- 8
Disconnect Battery Cable
1 minPry the battery flex connector straight up from its socket on the logic board using a plastic spudger.
- 9
Disconnect Interconnect Cable
1 minUse a spudger to snap off the main interconnect flex cable connecting the logic board to the bottom board.
- 10
Disconnect Display Cable
1 minUnplug the display flex cable press connector located near the right side of the board.
- 11
Disconnect Antenna Cables
2 minUse fine tweezers to carefully pry up the white and black coaxial antenna cables from their logic board connectors.
- 12
Remove Front Camera
2 minDisconnect the front camera flex cable and lift the camera module out of its recessed housing.
- 13
Remove Rear Camera Assembly
3 minDisconnect each rear camera flex cable connector, then lift the camera cluster away from the motherboard.
- 14
Unscrew Motherboard
1 minRemove the single remaining Phillips screw securing the logic board directly to the phone's frame.
- 15
Extract Logic Board
2 minGently pry beneath the bottom edge of the motherboard with a spudger and lift it out of the chassis.
- 16
Seat Replacement Board
2 minAlign the replacement or repaired logic board into the chassis and press lightly until it sits flush.
After your Motorola G200 5G logic board repair
Power the G200 5G back on and test the logic board repair function before you put every screw away. Check touch/display response, charging, cameras, buttons, and wireless as relevant to this repair. If something fails after closing the device, reopen carefully and reseat the connectors for this Motorola G200 5G job before assuming the part is defective. Keep leftover adhesive and screws labeled in case you need a second pass.
Keep learning
Explore more Motorola G200 5G repair context in the encyclopedia, or open related DIY guides.
