Phone · Motorola · G Power 5G
Motorola G Power 5G Speaker Repair
Speaker Repair guide for the Motorola G Power 5G
Before you begin
Tools
- Phillips #00 screwdriver
- Heat gun or iOpener
- Suction cup
- Plastic opening picks
- Spudger
- Tweezers
- SIM card eject tool
Parts / materials
- Replacement loudspeaker module
- Back cover adhesive tape
- Isopropyl alcohol (90%+)
- Lint-free cloth
Safety
- Power off the phone completely before starting the repair.
- Wear eye protection when heating or prying glass and plastic panels.
- Do not puncture or bend the battery while working near internal components.
- Use isopropyl alcohol in a well-ventilated space away from open flames.
Overview
Step-by-step
- 1
Eject SIM tray
1 minInsert a SIM eject tool into the hole next to the SIM tray on the left side of the phone and press firmly to eject it.
- 2
Heat the back panel
3 minApply a heated iOpener or heat gun around the edges of the back panel for two minutes to soften the adhesive.
- 3
Attach suction cup
2 minPlace a suction cup near the bottom edge of the back panel and pull upward to create a small gap.
- 4
Slice back panel adhesive
5 minInsert an opening pick into the gap and slowly slide it along the edges to slice through the adhesive.
- 5
Lift the back cover
2 minGently lift the right edge of the back cover like a book, taking care not to strain the fingerprint sensor cable.
- 6
Disconnect fingerprint sensor
2 minUse a plastic spudger to pry the fingerprint sensor flex connector straight up from the motherboard socket.
- 7
Unscrew loudspeaker assembly
3 minRemove the seven Phillips #00 screws securing the lower loudspeaker module to the frame.
- 8
Pry out loudspeaker module
2 minInsert a spudger under the plastic lip of the loudspeaker housing and gently pry it out of the chassis.
- 9
Clean speaker recess
3 minRemove any leftover adhesive or debris from the loudspeaker frame area using tweezers and isopropyl alcohol.
- 10
Install replacement loudspeaker
2 minPosition the new loudspeaker assembly over the lower frame and press down firmly until it snaps into place.
- 11
Secure loudspeaker screws
3 minReinstall the seven Phillips #00 screws into the loudspeaker assembly until snug.
- 12
Reconnect fingerprint flex
2 minAlign the fingerprint sensor press connector over its socket and press down until it clicks into position.
- 13
Apply new cover adhesive
4 minPeel and apply fresh pre-cut adhesive tape along the perimeter of the inner phone frame.
- 14
Reseal back cover
2 minAlign the back cover with the frame and press firmly along all edges to seat the adhesive.
After your Motorola G Power 5G speaker repair
Power the G Power 5G back on and test the speaker repair function before you put every screw away. Check touch/display response, charging, cameras, buttons, and wireless as relevant to this repair. If something fails after closing the device, reopen carefully and reseat the connectors for this Motorola G Power 5G job before assuming the part is defective. Keep leftover adhesive and screws labeled in case you need a second pass.
Keep learning
Explore more Motorola G Power 5G repair context in the encyclopedia, or open related DIY guides.
