Phone · Motorola · Moto Edge 60 Stylus
Motorola Moto Edge 60 Stylus Speaker Repair
Speaker Repair guide for the Motorola Moto Edge 60 Stylus
Before you begin
Tools
- Heat gun or hair dryer
- Suction cup tool
- Plastic prying tools
- Phillips #000 screwdriver
- Spudger tool
- Tweezers
- SIM card eject tool
Parts / materials
- Replacement loudspeaker module
- Pre-cut back cover adhesive
- Isopropanol alcohol wipes
Safety
- Wear protective safety glasses when applying heat to glass panels.
- Do not puncture or apply excessive force near the internal battery.
- Keep heating tools at a safe distance to prevent melting plastic components.
Overview
Step-by-step
- 1
Power Down Device
1 minPress and hold the power button, then select Power Off on the screen to completely turn off the phone.
- 2
Remove Stylus and SIM Tray
1 minEject the SIM tray using a SIM eject tool and pull the stylus straight out from its spring cavity.
- 3
Heat Back Cover
2 minApply moderate heat from a heat gun along all four edges of the rear panel for 2 minutes to soften the glue.
- 4
Attach Suction Cup
1 minPlace a suction cup near the bottom edge of the back panel and press down to firmly engage the suction.
- 5
Create Opening Gap
2 minPull up gently on the suction cup ring to create a small gap, then insert a plastic prying pick into the seam.
- 6
Slice Rear Adhesive
3 minSlide the plastic pick along all sides of the frame to separate the perimeter adhesive securing the back cover.
- 7
Lift Off Back Cover
2 minCarefully tilt up and remove the back panel from the chassis, taking care not to strain any sensor flex cables.
- 8
Unscrew Lower Speaker Frame
3 minUse a Phillips #000 screwdriver to remove the screws holding the lower loudspeaker housing in place.
- 9
Pry Up Loudspeaker Assembly
2 minInsert the flat end of a spudger beneath the edge of the speaker module and gently leverage it up out of the chassis.
- 10
Clean Speaker Recess
2 minUse tweezers and a lint-free cloth to clear out any remaining adhesive fragments or dust inside the speaker cavity.
- 11
Position New Loudspeaker
2 minSet the new replacement loudspeaker module into the lower frame, ensuring spring contact pins align properly.
- 12
Secure Speaker Screws
2 minReinstall and tighten the Phillips #000 screws evenly to clamp the loudspeaker module into place.
- 13
Remove Old Rear Adhesive
3 minPeel away old adhesive tape strips from both the perimeter frame and the inner back cover surface.
- 14
Apply New Back Cover Adhesive
3 minAlign and stick pre-cut adhesive tape strips along the perimeter edges of the phone frame.
- 15
Press Back Cover On
2 minAlign the rear panel with the frame and press down firmly around all edges for 30 seconds to set the seal.
- 16
Reinsert Stylus and SIM Tray
1 minPush the SIM card tray back into its slot and slide the stylus into its housing until it clicks.
After your Motorola Moto Edge 60 Stylus speaker repair
Power the Moto Edge 60 Stylus back on and test the speaker repair function before you put every screw away. Check touch/display response, charging, cameras, buttons, and wireless as relevant to this repair. If something fails after closing the device, reopen carefully and reseat the connectors for this Motorola Moto Edge 60 Stylus job before assuming the part is defective. Keep leftover adhesive and screws labeled in case you need a second pass.
Keep learning
Explore more Motorola Moto Edge 60 Stylus repair context in the encyclopedia, or open related DIY guides.
