Phone · Motorola · Moto Edge 50
Motorola Moto Edge 50 Speaker Repair
Speaker Repair guide for the Motorola Moto Edge 50
Before you begin
Tools
- Heat gun or hair dryer
- Suction cup tool
- Plastic prying tools
- Spudger tool
- Precision screwdriver set (Phillips #000)
- Tweezers
- Anti-static wrist strap
Parts / materials
- Replacement loudspeaker module
- Replacement back cover adhesive strips
- Isopropyl alcohol (99%)
Safety
- Wear safety glasses to protect against potential glass fragments from damaged back covers.
- Keep heat application below 80°C (176°F) to prevent damage to internal components.
- Use an anti-static wrist strap to prevent electrostatic discharge while handling internal electronics.
Overview
Step-by-step
- 1
Power off the device
1 minPress and hold the power button, then select Power Off on the screen. Ensure the phone is completely powered down before proceeding.
- 2
Heat the rear panel
2 minApply heat to the edges of the back cover using a heat gun for two minutes to soften the rear adhesive.
- 3
Attach the suction cup
1 minPress a suction cup firmly near the bottom edge of the back panel to create a strong seal.
- 4
Slice the perimeter adhesive
4 minPull up on the suction cup to create a small gap, then insert a plastic opening pick. Slide the pick along all edges to slice the adhesive.
- 5
Remove the back cover
2 minCarefully lift the rear cover off the phone frame and place it on a clean workspace.
- 6
Unscrew the loudspeaker assembly
3 minUse a Phillips #000 screwdriver to remove the screws securing the lower loudspeaker cover to the chassis.
- 7
Pry up the loudspeaker module
2 minInsert the flat edge of a spudger beneath the release notch on the speaker housing and gently pry it upward.
- 8
Remove the old loudspeaker
1 minLift the loudspeaker assembly out of the lower recess using tweezers.
- 9
Clean the speaker recess
2 minApply a small amount of isopropyl alcohol to a cotton swab and clean out any debris or adhesive residue from the speaker cavity.
- 10
Install the new loudspeaker
2 minPosition the replacement loudspeaker module into the lower cavity and press it gently into place until flush.
- 11
Secure the speaker screws
3 minReinstall the Phillips #000 screws to firmly fasten the loudspeaker module to the phone frame.
- 12
Apply new rear adhesive
3 minPeel and stick custom-cut rear adhesive tape along the perimeter of the internal frame.
- 13
Reseal the back cover
2 minAlign the back cover with the phone frame and press firmly along the edges to secure the seal.
After your Motorola Moto Edge 50 speaker repair
Power the Moto Edge 50 back on and test the speaker repair function before you put every screw away. Check touch/display response, charging, cameras, buttons, and wireless as relevant to this repair. If something fails after closing the device, reopen carefully and reseat the connectors for this Motorola Moto Edge 50 job before assuming the part is defective. Keep leftover adhesive and screws labeled in case you need a second pass.
Keep learning
Explore more Motorola Moto Edge 50 repair context in the encyclopedia, or open related DIY guides.
