Phone · Motorola · Moto Edge 50 Neo
Motorola Moto Edge 50 Neo Speaker Repair
Speaker Repair guide for the Motorola Moto Edge 50 Neo
Before you begin
Tools
- Phillips #00 screwdriver
- Heat gun or iOpener
- Suction cup
- Plastic opening picks
- Spudger
- Tweezers
- SIM eject tool
Parts / materials
- Replacement loudspeaker module
- Back cover adhesive strips
- Isopropyl alcohol (99%)
Safety
- Wear eye protection when heating glass panels to protect against sudden shattering.
- Disconnect the battery immediately after opening the device to avoid electrical shorts.
- Do not puncture or bend the internal lithium-ion battery during disassembly.
Overview
Step-by-step
- 1
Power off device
2 minTurn off your Moto Edge 50 Neo and remove the SIM card tray using a SIM eject tool.
- 2
Heat back panel
2 minApply a heat gun or heating pad to the edges of the back cover for two minutes to soften the perimeter adhesive.
- 3
Attach suction cup
1 minPlace a suction cup on the lower half of the back cover and pull upward gently to create a seam.
- 4
Insert opening pick
1 minInsert a plastic opening pick into the gap created between the back cover and the frame.
- 5
Slice adhesive tape
3 minSlide the pick around all four edges of the back cover to completely slice through the adhesive.
- 6
Remove back cover
1 minLift the back cover straight off the frame and set it aside.
- 7
Unscrew top bracket
3 minUnscrew the Phillips #00 screws securing the upper motherboard shield.
- 8
Remove motherboard shield
1 minUse a plastic spudger to lever up and remove the motherboard shield from the frame.
- 9
Disconnect battery
1 minPry the battery press connector straight up off the motherboard using the flat end of a spudger.
- 10
Unscrew speaker housing
2 minRemove the Phillips #00 screws securing the bottom loudspeaker assembly to the frame.
- 11
Pry up speaker assembly
1 minInsert a spudger under the edge of the loudspeaker module and gently lever it up.
- 12
Remove old speaker
1 minLift the loudspeaker module out of the lower phone body.
- 13
Install new speaker
1 minAlign the replacement loudspeaker assembly in the lower frame recess and press it into place.
- 14
Secure speaker housing
2 minReinstall and tighten the Phillips #00 screws to secure the speaker assembly.
- 15
Reconnect battery
1 minAlign the battery flex connector over its socket and press firmly down until it clicks into place.
- 16
Reinstall motherboard shield
3 minPosition the upper motherboard shield back onto the board and replace all securing screws.
- 17
Apply back adhesive
3 minClean remaining adhesive off the frame edges and lay down new pre-cut back cover adhesive.
- 18
Reattach back cover
2 minAlign the back cover over the chassis and press firmly along the edges to seal it.
After your Motorola Moto Edge 50 Neo speaker repair
Power the Moto Edge 50 Neo back on and test the speaker repair function before you put every screw away. Check touch/display response, charging, cameras, buttons, and wireless as relevant to this repair. If something fails after closing the device, reopen carefully and reseat the connectors for this Motorola Moto Edge 50 Neo job before assuming the part is defective. Keep leftover adhesive and screws labeled in case you need a second pass.
Keep learning
Explore more Motorola Moto Edge 50 Neo repair context in the encyclopedia, or open related DIY guides.
