Phone · Motorola · Moto Edge 30 Fusion
Motorola Moto Edge 30 Fusion Speaker Repair
Speaker Repair guide for the Motorola Moto Edge 30 Fusion
Before you begin
Tools
- Heat gun or iOpener
- Suction handle
- Opening picks
- Phillips #00 screwdriver
- Precision tweezers
- Spudger
- SIM eject tool
Parts / materials
- Replacement loudspeaker module
- Pre-cut back glass adhesive strip
- 99% Isopropyl alcohol
- Microfiber cleaning cloth
Safety
- Wear safety glasses to protect against splintered glass when removing the rear panel.
- Do not puncture or bend the internal battery with metal tools.
- Work in a well-ventilated area when using isopropyl alcohol.
Overview
Step-by-step
- 1
Power down and eject SIM tray
1 minTurn off your Moto Edge 30 Fusion completely. Insert a SIM eject tool into the hole next to the SIM tray on the bottom edge to remove it.
- 2
Heat the back panel edges
3 minApply a heat gun or heating pad to the outer perimeter of the back glass for 2-3 minutes to soften the rear panel adhesive.
- 3
Attach suction cup
2 minPlace a suction handle near the bottom edge of the back glass and pull upward firmly to create a small gap.
- 4
Insert opening pick
2 minInsert an opening pick into the seam between the back glass and the middle frame.
- 5
Slice back cover adhesive
4 minSlide the opening pick along all four edges of the back cover to cut through the adhesive seal. Reapply heat if the pick meets heavy resistance.
- 6
Remove back glass cover
2 minLift the rear glass off the chassis gently. Set the glass aside on a soft surface.
- 7
Unscrew loudspeaker housing
3 minUse a precision Phillips screwdriver to remove the screws securing the lower plastic speaker housing cover.
- 8
Pry up loudspeaker module
2 minInsert a spudger beneath the edge of the lower speaker assembly and gently lift it out of the chassis.
- 9
Remove faulty loudspeaker
1 minLift the speaker module out completely and inspect the cavity for any debris or metal shavings.
- 10
Insert new loudspeaker module
2 minAlign the replacement loudspeaker module with the mounting pegs in the lower compartment and press it flat into place.
- 11
Secure loudspeaker screws
3 minReinstall and tighten all Phillips screws to secure the loudspeaker housing into the frame.
- 12
Clean frame adhesive
4 minUse tweezers and a lint-free cloth dampened with 99% isopropyl alcohol to remove all old adhesive from the frame and back glass.
- 13
Apply replacement adhesive
3 minPeel the backing from the custom pre-cut adhesive tape and press it precisely along the perimeter of the phone frame.
- 14
Reattach back glass cover
2 minAlign the rear glass cover with the frame edges and press down firmly around the entire perimeter to seal it.
- 15
Reinsert SIM card tray
1 minSlide the SIM card tray back into its slot on the bottom of the device until it sits flush.
After your Motorola Moto Edge 30 Fusion speaker repair
Power the Moto Edge 30 Fusion back on and test the speaker repair function before you put every screw away. Check touch/display response, charging, cameras, buttons, and wireless as relevant to this repair. If something fails after closing the device, reopen carefully and reseat the connectors for this Motorola Moto Edge 30 Fusion job before assuming the part is defective. Keep leftover adhesive and screws labeled in case you need a second pass.
Keep learning
Explore more Motorola Moto Edge 30 Fusion repair context in the encyclopedia, or open related DIY guides.
