Phone · Motorola · Moto E6S
Motorola Moto E6S Speaker Repair
Speaker Repair guide for the Motorola Moto E6S
Before you begin
Tools
- Phillips #000 screwdriver
- Plastic opening pick
- Spudger tool
- SIM card eject tool
- Tweezers
Parts / materials
- Replacement Moto E6S loudspeaker assembly
Safety
- Power off the phone completely before beginning disassembly.
- Disconnect the battery flex cable before replacing internal parts.
- Wear an anti-static wrist strap to avoid ESD damage to sensitive board components.
Overview
Step-by-step
- 1
Power Off the Phone
1 minPress and hold the power button, then select power off to turn off the Moto E6S completely.
- 2
Eject the SIM Card Tray
1 minInsert a SIM eject tool into the hole on the left edge of the phone to release the card tray.
- 3
Unsnap the Rear Panel
3 minInsert a plastic opening pick into the seam between the back cover and display frame, then slide it around the perimeter to release the plastic clips.
- 4
Disconnect the Fingerprint Sensor
2 minGently lift the back cover slightly and use a spudger to pop the fingerprint reader flex cable off the mainboard.
- 5
Remove Loudspeaker Screws
2 minUse a Phillips #000 screwdriver to remove the screws holding down the lower speaker housing bracket.
- 6
Pry Up Loudspeaker Assembly
2 minInsert the flat end of a spudger under the notch of the loudspeaker module and lift it out of the frame.
- 7
Disconnect Battery Connector
1 minPry the battery flex cable directly up from its motherboard socket to prevent electrical shorts during repair.
- 8
Install New Speaker Assembly
2 minPosition the new loudspeaker module into the lower housing cavity and press down until it sits flush.
- 9
Reconnect Battery Cable
1 minAlign and snap the battery flex cable connector back onto its mainboard socket.
- 10
Secure Loudspeaker Cover
2 minReinstall the lower speaker housing and tighten the Phillips #000 screws until snug.
- 11
Reconnect Fingerprint Flex
2 minHold the rear cover near the frame and press the fingerprint sensor flex cable connector back onto the motherboard.
- 12
Attach Rear Panel
2 minAlign the back cover over the phone body and press firmly along the edges until all clips snap securely into place.
- 13
Reinsert SIM Card Tray
1 minPush the SIM and MicroSD card tray back into its slot on the side of the device.
After your Motorola Moto E6S speaker repair
Power the Moto E6S back on and test the speaker repair function before you put every screw away. Check touch/display response, charging, cameras, buttons, and wireless as relevant to this repair. If something fails after closing the device, reopen carefully and reseat the connectors for this Motorola Moto E6S job before assuming the part is defective. Keep leftover adhesive and screws labeled in case you need a second pass.
Keep learning
Explore more Motorola Moto E6S repair context in the encyclopedia, or open related DIY guides.
