Phone · Motorola · Moto E6 Plus
Motorola Moto E6 Plus Logic Board Repair
Logic Board Repair guide for the Motorola Moto E6 Plus
Before you begin
Tools
- Precision screwdriver set (Phillips #00)
- Plastic prying tools
- Spudger tool
- Tweezers
- Anti-static wrist strap
Parts / materials
- Replacement Moto E6 Plus logic board
- Isopropyl alcohol (99%)
- Lint-free cleaning wipes
Safety
- Wear an anti-static wrist strap grounded to a metal surface to prevent electrostatic discharge damage.
- Ensure the phone is powered off and the battery is completely removed before disconnecting internal flex cables.
- Do not bend or puncture flex cables during removal and installation.
Overview
Step-by-step
- 1
Power down the phone
1 minPress and hold the power button until the menu appears, then select Power Off.
- 2
Remove the rear cover
2 minInsert a plastic pry tool into the notch at the bottom edge and pry the rear cover away from the chassis.
- 3
Remove the battery
1 minUse a spudger or your fingernail to lift the removable battery out from the bottom notch of the compartment.
- 4
Remove SIM and microSD cards
1 minSlide the SIM card and microSD card out of their respective slots on the upper frame.
- 5
Unscrew the upper motherboard cover
3 minRemove the Phillips #00 screws securing the top plastic cover over the logic board.
- 6
Detach the upper motherboard cover
2 minInsert a plastic prying tool under the top plastic cover and gently lift it off the frame.
- 7
Disconnect the display flex cable
2 minUse the flat end of a spudger to pop the display ZIF/press connector straight up off the board.
- 8
Disconnect the sub-board flex cable
2 minPry up the interconnect flex cable connector linking the lower board to the main logic board.
- 9
Remove the front camera
2 minDisconnect the front camera flex connector with a spudger and lift the module out using tweezers.
- 10
Remove the rear camera assembly
3 minUnplug the dual rear camera press connectors and lift the camera module out of its recess.
- 11
Remove the logic board screw
2 minUnscrew the single Phillips #00 screw holding the logic board to the internal midframe.
- 12
Lift out the logic board
2 minGently insert a spudger under the top edge of the logic board and lift it out of the chassis.
- 13
Position the new logic board
2 minPlace the replacement logic board into the frame, aligning it with the screw hole and plastic mounting pegs.
- 14
Reconnect internal components
4 minReattach the front camera, rear camera assembly, display cable, and sub-board interconnect cable to their board connectors.
- 15
Reinstall motherboard cover and battery
3 minSecure the top plastic cover with its Phillips screws, reinsert the battery, and snap the rear cover back onto the phone.
After your Motorola Moto E6 Plus logic board repair
Power the Moto E6 Plus back on and test the logic board repair function before you put every screw away. Check touch/display response, charging, cameras, buttons, and wireless as relevant to this repair. If something fails after closing the device, reopen carefully and reseat the connectors for this Motorola Moto E6 Plus job before assuming the part is defective. Keep leftover adhesive and screws labeled in case you need a second pass.
Keep learning
Explore more Motorola Moto E6 Plus repair context in the encyclopedia, or open related DIY guides.
