Phone · Motorola · Moto E32
Motorola Moto E32 Water Damage Repair
Water Damage Repair guide for the Motorola Moto E32
Before you begin
Tools
- Heat gun or hair dryer
- Phillips #00 screwdriver
- Plastic prying tools
- Spudger tool
- Soft brush
- SIM eject tool
- Tweezers
- Compressed air
Parts / materials
- Isopropyl alcohol (99%)
- Clean workspace mat
- Microfiber cloth
- Pre-cut back cover adhesive
Safety
- Disconnect the battery before cleaning or removing electronic boards.
- Work in a well-ventilated area when using high-concentration isopropyl alcohol.
- Wear safety glasses when handling compressed air and scrubbing corroded components.
Overview
Step-by-step
- 1
Power Off Device
1 minPress and hold the power button, then select power off to prevent short circuits during repair.
- 2
Eject SIM Tray
1 minInsert a SIM eject tool into the small hole on the left edge of the phone to pop out the card tray.
- 3
Heat Back Cover
2 minApply mild heat around the outer perimeter of the back cover for 1-2 minutes to soften the adhesive.
- 4
Slice Perimeter Adhesive
3 minInsert a plastic opening pick under the plastic back cover edge and slice through the adhesive around all sides.
- 5
Remove Back Cover
1 minCarefully lift the rear cover off the phone frame and set it aside.
- 6
Unscrew Rear Midframe
3 minRemove all Phillips #00 screws securing the protective plastic midframe cover.
- 7
Pry Off Midframe
2 minInsert a spudger beneath the plastic midframe edges to unclip and remove it from the device.
- 8
Disconnect Battery Press Connector
1 minUse a plastic spudger to gently pry up the battery flex cable connector from the motherboard.
- 9
Unplug Display and Daughterboard Cables
2 minDisconnect the screen flex cable and lower sub-board interconnect cables from the motherboard.
- 10
Extract Main Logic Board
2 minUnscrew any remaining motherboard retention screws and carefully lift the main logic board out of the chassis.
- 11
Inspect Board for Corrosion
2 minExamine the logic board for white or green mineral deposits, focusing on connectors and liquid damage indicators.
- 12
Scrub Corrosion with Isopropyl Alcohol
5 minDip a soft brush in 99% isopropyl alcohol and scrub away corrosion from all exposed logic board components.
- 13
Dry Component Boards
15 minUse compressed air to blow away loose alcohol and leave the board in a dry area for 15 minutes.
- 14
Clean USB Daughterboard
4 minRemove the lower speaker assembly and scrub the charging port sub-board thoroughly with isopropyl alcohol.
- 15
Reinstall Boards and Reconnect Battery
5 minReassemble the logic boards and interconnect cables, then plug the battery back in before securing the midframe.
After your Motorola Moto E32 water damage repair
Power the Moto E32 back on and test the water damage repair function before you put every screw away. Check touch/display response, charging, cameras, buttons, and wireless as relevant to this repair. If something fails after closing the device, reopen carefully and reseat the connectors for this Motorola Moto E32 job before assuming the part is defective. Keep leftover adhesive and screws labeled in case you need a second pass.
Keep learning
Explore more Motorola Moto E32 repair context in the encyclopedia, or open related DIY guides.
