Step-by-step

1. 1

   Turn Off Phone

   1 min

   Press and hold the Power and Volume Up buttons simultaneously, then select Power Off on the screen. Ensure the device is completely powered down before proceeding.

2. 2

   Eject SIM Tray

   1 min

   Insert a SIM eject tool or paperclip into the hole next to the SIM tray on the bottom edge. Push firmly straight in until the tray pops out, then remove it.

3. 3

   Heat Rear Glass

   3 min

   Apply a heat gun or hairdryer set to low heat around the outer perimeter of the back panel for 2 to 3 minutes. This softens the perimeter adhesive holding the rear glass to the frame.

4. 4

   Attach Suction Cup

   2 min

   Place a suction cup onto the lower portion of the rear glass and press firmly to seal it. Gently pull upward on the suction cup handle to create a small gap along the edge.

5. 5

   Slice Adhesive

   4 min

   Insert a thin plastic opening pick into the gap created beneath the rear glass. Carefully slide the pick along all edges to cut through the internal adhesive tape.

6. 6

   Lift Rear Glass

   2 min

   Slowly lift the rear glass off the frame like a book cover. Disconnect any attached sensor ribbon cables if applicable before fully removing the panel.

7. 7

   Unscrew Midframe Shield

   3 min

   Use a precision screwdriver to remove all visible screws securing the metal midframe shield and wireless charging coil array. Keep screws organized by size and position.

8. 8

   Remove Midframe Shield

   2 min

   Insert the flat end of a spudger under the edge of the midframe cover and gently pry it upward. Carefully lift the shield clear of the device chassis.

9. 9

   Disconnect Battery Cable

   1 min

   Locate the battery press connector on the motherboard assembly. Use a plastic spudger to snap the connector straight up to isolate power.

10. 10

    Disconnect Camera Modules

    3 min

    Use a spudger to pop off the press connectors for the front selfie camera and rear camera cluster. Carefully lift the loose camera modules out of their housings.

11. 11

    Disconnect Antenna Flexes

    2 min

    Gently unsnap the coaxial antenna connectors along the sides of the motherboard using precision tweezers. Take care not to damage the delicate metal sockets.

12. 12

    Unscrew Logic Board

    3 min

    Remove the remaining retaining screws anchoring the logic board directly to the aluminum chassis frame. Store these separately from the midframe screws.

13. 13

    Remove Logic Board

    2 min

    Insert a spudger beneath the lower corner of the logic board and gently pry upward. Carefully lift the board out of the phone body, ensuring no cables snag.

14. 14

    Install New Logic Board

    5 min

    Transfer any thermal pads or brackets to the replacement logic board and align it into the chassis. Reverse the disassembly process to reconnect cables, replace shields, and reseal the back glass.