Phone · Google · Pixel 8
Google Pixel 8 Back Glass Repair
Back Glass Repair guide for the Google Pixel 8
Before you begin
Tools
- Heat gun or iOpener
- Suction cup
- Opening picks
- Plastic spudger
- Tweezers
- Precision screwdriver set
- Anti-static wrist strap
Parts / materials
- Replacement Google Pixel 8 back glass
- Pre-cut back glass adhesive
- 90%+ Isopropyl alcohol
- Lint-free microfiber cloth
Safety
- Wear eye protection to prevent injury from loose glass splinters.
- Cover severely cracked glass with packing tape before applying heat to keep shards intact.
- Avoid pressing or prying against the internal battery with metal tools.
Overview
Step-by-step
- 1
Power Off Phone
1 minPress and hold the Power and Volume Up buttons simultaneously, then select Power Off on the screen.
- 2
Heat Bottom Edge
2 minApply a heated iOpener or heat gun to the bottom edge of the back glass for two minutes to soften the adhesive.
- 3
Attach Suction Cup
1 minPlace a suction cup onto the lower portion of the back panel and pull upward to create a thin gap.
- 4
Insert Opening Pick
2 minSlide an opening pick into the gap between the rear glass and the aluminum frame at the bottom edge.
- 5
Slice Left Edge Adhesive
3 minApply heat to the left edge, then slide the opening pick up the left side to separate the perimeter adhesive.
- 6
Slice Top Edge Adhesive
3 minWarm the top edge with your heat source and carefully cut through the adhesive seam with the pick.
- 7
Slice Right Edge Adhesive
3 minHeat the right edge and guide the pick down the side to release the final adhesive section.
- 8
Pry Glass Open
2 minGently swing the back glass open toward the right side like a book cover.
- 9
Unclip Wireless Charging Cable
2 minUse a plastic spudger to pry up and disconnect the wireless charging coil press connector from the board.
- 10
Remove Rear Glass
1 minLift the old back glass completely away from the phone body and place it on your work surface.
- 11
Clean Frame Adhesive
5 minScrape away remaining adhesive residue from the frame edges using isopropyl alcohol and a plastic spudger.
- 12
Apply Replacement Adhesive
3 minPeel the protective backing from the custom adhesive strip and carefully press it around the frame perimeter.
- 13
Connect Coil Cable
2 minAlign the wireless charging coil connector with its socket on the board and press down gently until it clicks.
- 14
Install New Back Glass
3 minAlign the new back glass with the outer frame and press firmly along all edges to set the adhesive seal.
After your Google Pixel 8 back glass repair
Power the Pixel 8 back on and test the back glass repair function before you put every screw away. Check touch/display response, charging, cameras, buttons, and wireless as relevant to this repair. If something fails after closing the device, reopen carefully and reseat the connectors for this Google Pixel 8 job before assuming the part is defective. Keep leftover adhesive and screws labeled in case you need a second pass.
Keep learning
Explore more Google Pixel 8 repair context in the encyclopedia, or open related DIY guides.
