Phone · Google · Pixel 6 Pro
Google Pixel 6 Pro Charging Port Repair
Charging Port Repair guide for the Google Pixel 6 Pro
Before you begin
Tools
- T5 Torx screwdriver
- Heat gun or iOpener
- Suction cup handle
- Plastic opening picks
- Spudger
- Tweezers
- SIM eject tool
Parts / materials
- Replacement Pixel 6 Pro charging port board
- Pre-cut display adhesive strips
- Isopropyl alcohol (99%)
Safety
- Wear eye protection when heating display glass to guard against shattering shards.
- Disconnect the battery press connector before removing any internal daughterboards to avoid electrical shorts.
- Do not bend or puncture the lithium-ion battery during disassembly.
Overview
Step-by-step
- 1
Power Off Device
1 minPress and hold the power button, then select power off to shut down the Pixel 6 Pro completely.
- 2
Heat Display Edges
3 minApply a heated pad or heat gun around the perimeter of the screen for two minutes to soften the display adhesive.
- 3
Attach Suction Handle
2 minPlace a suction cup near the bottom edge of the display glass and pull up firmly to create a gap.
- 4
Insert Opening Pick
2 minSlide a thin plastic opening pick into the gap between the glass screen and the phone frame.
- 5
Slice Screen Adhesive
5 minSlide the pick around all four edges of the device to cut through the internal frame adhesive.
- 6
Open Display Assembly
2 minGently lift the display open from the left edge like a book page, taking care not to strain the flex cable.
- 7
Unscrew Display Cable Shield
2 minUse a T5 Torx driver to remove the two screws securing the metal display cable cover bracket.
- 8
Disconnect Display Cable
2 minLift off the metal bracket and pry the display press connector straight up from the motherboard.
- 9
Remove SIM Card Tray
1 minInsert a SIM eject tool into the tray hole on the side of the frame and remove the SIM card assembly.
- 10
Unscrew Midframe Assembly
4 minRemove the T5 Torx screws holding the midframe and motherboard shielding to the chassis.
- 11
Remove Midframe
2 minCarefully pry up and remove the midframe assembly to expose the internal components.
- 12
Disconnect Battery Cable
1 minUse a plastic spudger to disconnect the battery press connector from the motherboard to cut power.
- 13
Unscrew Loudspeaker Module
3 minRemove the T5 Torx screws securing the bottom speaker housing over the charging port area.
- 14
Remove Loudspeaker Module
2 minPry the bottom speaker module up and out of the phone body using a plastic opening tool.
- 15
Disconnect Antenna Coaxial Cables
2 minUse tweezers to carefully pop off the coaxial antenna cables attached to the daughterboard.
- 16
Unscrew Charging Port Board
2 minRemove the retaining screws holding the charging port board to the lower frame assembly.
- 17
Remove Defective Port Board
2 minGently pry up and lift the old charging port daughterboard out of the lower frame housing.
- 18
Install New Charging Port Board
3 minAlign the replacement charging port board into the lower recess and press it firmly into place.
After your Google Pixel 6 Pro charging port repair
Power the Pixel 6 Pro back on and test the charging port repair function before you put every screw away. Check touch/display response, charging, cameras, buttons, and wireless as relevant to this repair. If something fails after closing the device, reopen carefully and reseat the connectors for this Google Pixel 6 Pro job before assuming the part is defective. Keep leftover adhesive and screws labeled in case you need a second pass.
Keep learning
Explore more Google Pixel 6 Pro repair context in the encyclopedia, or open related DIY guides.
