Phone · Apple · iPhone SE 2022
Power Button Repair Guide for iPhone SE 2022
Power Button Repair guide for the Apple iPhone SE 2022
Before you begin
Tools
- P2 Pentalobe Screwdriver
- Tri-point Y000 Screwdriver
- Phillips #000 Screwdriver
- Standoff Screwdriver for iPhone
- Suction Cup Tool
- Opening Picks
- Spudger Tool
- Precision Tweezers
- Heat Gun or iOpener
Parts / materials
- Replacement iPhone SE 2022 Power Button Cable Assembly
- Display Assembly Adhesive Strip
- Isopropyl Alcohol (99%)
Safety
- Always disconnect the battery before working near internal electronics to prevent short circuits.
- Wear safety glasses when handling heating tools and glass display assemblies.
- Do not puncture or bend the lithium-ion battery during disassembly.
Overview
Step-by-step
- 1
Power Off the Device
1 minPress and hold the side button and volume down button until the slider appears. Slide to power off your iPhone SE completely before starting.
- 2
Remove the Pentalobe Screws
2 minUse a P2 Pentalobe screwdriver to remove the two 3.5 mm screws located on either side of the Lightning charging port.
- 3
Heat the Display Edges
3 minApply a heated iOpener or heat gun around the bottom edge of the display for two minutes to soften the waterproof adhesive seal.
- 4
Attach Suction Cup
2 minPlace a suction cup on the lower half of the front glass, just above the Home button, and press firmly to secure it.
- 5
Slice the Display Adhesive
4 minPull up on the suction cup to create a small gap, then insert an opening pick into the bottom edge and slide along the left side to sever the adhesive.
- 6
Open the Display Assembly
2 minSwing the display open from the left edge like a book, taking care not to strain the delicate ribbon cables along the right side.
- 7
Remove Logic Board Bracket
3 minUnscrew the four Tri-point Y000 screws securing the lower display bracket and remove the bracket with tweezers.
- 8
Disconnect the Battery
2 minUse the flat end of a spudger to pry the battery connector straight up from its socket on the logic board.
- 9
Disconnect Display Cables
4 minUse a spudger to disconnect the display cable connector and the lower sensor assembly cable, then free the screen completely.
- 10
Remove Rear Camera Bracket
3 minUnscrew the Phillips #000 screws holding the rear camera bracket in place and carefully lift the metal shield out of the chassis.
- 11
Remove Logic Board Fasteners
5 minRemove the Standoff screws and Phillips screws securing the upper portion of the logic board to the rear enclosure.
- 12
Extract the Logic Board
4 minGently lift the logic board out of the case, ensuring no remaining flex cables snag on components as you remove it.
- 13
Unscrew Power Button Bracket
3 minRemove the two Phillips screws holding the power button metal bracket against the upper right interior frame.
- 14
Peel Up Power Button Cable
4 minUse precision tweezers to lift the power button actuator bracket out and peel the thin flex cable away from the internal sidewall.
- 15
Install New Power Button Assembly
5 minAlign the replacement power button cable into the metal recess, secure the button actuator, and reinstall the mounting bracket.
After your Apple iPhone SE 2022 power button repair
Power the iPhone SE 2022 back on and test the power button repair function before you put every screw away. Check touch/display response, charging, cameras, buttons, and wireless as relevant to this repair. If something fails after closing the device, reopen carefully and reseat the connectors for this Apple iPhone SE 2022 job before assuming the part is defective. Keep leftover adhesive and screws labeled in case you need a second pass.
Keep learning
Explore more Apple iPhone SE 2022 repair context in the encyclopedia, or open related DIY guides.
