Phone · Apple · iPhone 16
Power Button Repair Guide for iPhone 16
Power Button Repair guide for the Apple iPhone 16
Before you begin
Tools
- P2 Pentalobe screwdriver
- Tri-point Y000 screwdriver
- Precision tweezers
- Plastic spudger
- Opening picks
- Suction cup tool
- Heat gun or hair dryer
Parts / materials
- Replacement iPhone 16 power button flex cable
- Pre-cut display adhesive gasket
- 90%+ Isopropyl alcohol
Safety
- Discharge the battery below 25% before starting to reduce the risk of thermal events if damaged.
- Wear eye protection when heating and prying glass components.
- Use an anti-static wrist strap to protect sensitive internal electronics from electrostatic discharge.
Overview
Step-by-step
- 1
Power Off the iPhone
1 minPress and hold the side button and either volume button, then slide to power off the device completely.
- 2
Remove the Pentalobe Screws
2 minUse a P2 Pentalobe driver to remove the two 6.8 mm screws located on the bottom edge of the phone.
- 3
Heat the Lower Edge
2 minApply a heat gun or hair dryer to the bottom edge of the iPhone for two minutes to soften the display adhesive.
- 4
Apply a Suction Cup
1 minPlace a suction cup near the bottom edge of the screen, just above the home indicator area.
- 5
Pry Open the Display
3 minPull up on the suction cup to create a small gap, then insert an opening pick under the screen.
- 6
Slice the Edge Adhesive
4 minSlide the pick around the perimeter of the phone to cut through the waterproof adhesive seal.
- 7
Open the Display Assembly
2 minGently swing the display open from the right edge, like opening the cover of a book.
- 8
Unscrew the Logic Board Cover
3 minUse a Tri-point screwdriver to remove the screws securing the lower connector bracket.
- 9
Disconnect the Battery
2 minUse the flat end of a spudger to pry the battery connector straight up from its socket.
- 10
Disconnect the Power Button Flex
3 minLocate the power button flex cable connector on the logic board and gently detach it using tweezers or a spudger.
- 11
Unscrew the Power Button Bracket
3 minRemove the small retaining screws holding the internal power button bracket to the frame.
- 12
Remove the Damaged Switch Assembly
2 minUse tweezers to lift the metal bracket and extract the power button flex cable from inside the housing.
- 13
Install the New Power Button
4 minPosition the replacement power button switch into the housing slot and secure it with the retaining bracket.
After your Apple iPhone 16 power button repair
Power the iPhone 16 back on and test the power button repair function before you put every screw away. Check touch/display response, charging, cameras, buttons, and wireless as relevant to this repair. If something fails after closing the device, reopen carefully and reseat the connectors for this Apple iPhone 16 job before assuming the part is defective. Keep leftover adhesive and screws labeled in case you need a second pass.
Keep learning
Explore more Apple iPhone 16 repair context in the encyclopedia, or open related DIY guides.
