Phone · Apple · iPhone 16 Plus
Apple iPhone 16 Plus Speaker Repair
Speaker Repair guide for the Apple iPhone 16 Plus
Before you begin
Tools
- P2 Pentalobe screwdriver
- Y000 Tri-point screwdriver
- Precision Phillips screwdriver
- Heat gun or hair dryer
- Suction cup tool
- Plastic prying tools
- Spudger tool
- Tweezers
Parts / materials
- Replacement iPhone 16 Plus loudspeaker module
- Precut rear glass adhesive seal
- Isopropanol alcohol (99%)
Safety
- Ensure the battery level is below 25% to decrease the risk of fire if damaged.
- Wear protective safety glasses when heating and working near glass components.
- Do not puncture, pry directly against, or bend the lithium-ion battery.
Overview
Step-by-step
- 1
Power Down Device
1 minPress and hold the side button and volume down button, then slide the screen slider to power off the iPhone completely.
- 2
Remove Pentalobe Screws
2 minUse a P2 Pentalobe screwdriver to remove the two 3.8 mm screws located on either side of the USB-C charging port.
- 3
Warm the Rear Glass
2 minApply a heat gun or hair dryer to the bottom edge of the rear glass panel for two minutes to soften the internal adhesive.
- 4
Apply Suction Handle
1 minPlace a suction cup tool onto the lower portion of the rear glass, just above the USB-C port, and press firmly to seal.
- 5
Insert Opening Pick
2 minPull up on the suction handle to create a tiny gap, then slide a plastic opening pick under the glass edge.
- 6
Slice Perimeter Adhesive
4 minCarefully slide the opening pick around the bottom and side edges of the back glass to separate the perimeter waterproof seal.
- 7
Open Back Panel
2 minGently swing the back panel open toward the right side like a book cover, taking care not to strain the ribbon cables.
- 8
Unscrew Bracket Cover
2 minUse a Y000 tri-point screwdriver to remove the screws securing the lower metal connector shield.
- 9
Disconnect Battery Connector
1 minPry the battery press connector straight up off its socket using the pointed end of a spudger to disable power.
- 10
Unfasten Speaker Module
3 minRemove the Phillips and Tri-point screws anchoring the loudspeaker housing to the bottom of the enclosure.
- 11
Remove Loudspeaker
2 minInsert a spudger under the edge of the loudspeaker assembly and lift it out of the rear case.
- 12
Install Replacement Speaker
3 minPosition the new speaker assembly into the lower cavity, press it flat, and reinstall the retaining screws.
- 13
Attach Battery and Bracket
3 minSnap the battery connector back onto the logic board and re-secure the protective metal cover plate with its screws.
- 14
Apply Adhesive and Close
4 minLay down fresh precut adhesive along the frame edges, align the back glass, and press firmly around the borders to seal.
After your Apple iPhone 16 Plus speaker repair
Power the iPhone 16 Plus back on and test the speaker repair function before you put every screw away. Check touch/display response, charging, cameras, buttons, and wireless as relevant to this repair. If something fails after closing the device, reopen carefully and reseat the connectors for this Apple iPhone 16 Plus job before assuming the part is defective. Keep leftover adhesive and screws labeled in case you need a second pass.
Keep learning
Explore more Apple iPhone 16 Plus repair context in the encyclopedia, or open related DIY guides.
