Step-by-step

1. 1

   Power down the device

   1 min

   Press and hold the side button and volume down button simultaneously until the sliders appear. Slide to power off the iPhone 15 Pro completely before starting.

2. 2

   Remove the bottom pentalobe screws

   2 min

   Use a P2 Pentalobe screwdriver to remove the two 1.5 mm screws located on either side of the USB-C port.

3. 3

   Heat the lower back glass edge

   2 min

   Apply a heat gun or hair dryer to the bottom rear edge for two minutes to soften the back glass adhesive.

4. 4

   Attach a suction cup to the rear glass

   1 min

   Place a suction cup on the lower half of the back glass, just above the USB-C port, and press down to create a seal.

5. 5

   Insert an opening pick under the back glass

   3 min

   Pull up gently on the suction cup to create a gap, then slide a plastic opening pick under the bottom edge of the glass.

6. 6

   Slice the perimeter back glass adhesive

   5 min

   Slide the opening pick carefully along the bottom, left, top, and right edges to separate the adhesive securing the back glass.

7. 7

   Open the back glass like a book

   2 min

   Gently swing the back glass open toward the right side of the phone frame, taking care not to strain the ribbon cables attached to the logic board.

8. 8

   Unscrew the lower connector shield

   3 min

   Use a Y000 Tri-point screwdriver to remove the screws securing the metal bracket over the battery and rear glass press connectors.

9. 9

   Remove the connector shield

   1 min

   Use tweezers to lift the metal shield off the logic board and set it aside.

10. 10

    Disconnect the battery press connector

    1 min

    Pry the battery cable connector straight up from its logic board socket using the pointed end of a spudger.

11. 11

    Disconnect the wireless charging coil cable

    1 min

    Use a spudger to gently pop the wireless charging and back glass press connector off the logic board.

12. 12

    Remove the wireless charging coil screws

    4 min

    Unscrew the small Y000 Tri-point screws retaining the wireless charging assembly to the inner face of the back glass.

13. 13

    Peel off the damaged wireless charging coil

    3 min

    Insert a flat opening pick under the edge of the coil assembly and carefully detach it from the back glass matrix.

14. 14

    Position the new wireless charging coil

    3 min

    Align the replacement wireless charging coil onto the inner side of the back glass, matching the alignment posts and screw holes.

15. 15

    Secure the replacement coil screws

    3 min

    Reinstall and tighten the Y000 Tri-point screws to fasten the new wireless charging module to the back panel.

16. 16

    Reconnect the wireless charging and battery cables

    2 min

    Align and press the wireless charging ribbon cable and battery connector firmly into their logic board sockets until they snap into place.

17. 17

    Reinstall the connector cover shield

    2 min

    Place the metal bracket back over the connectors and tighten the Y000 Tri-point screws.

18. 18

    Apply a fresh back glass adhesive seal

    4 min

    Clean off old adhesive, align a new pre-cut adhesive seal along the outer perimeter of the phone housing, and peel off the film backing.

19. 19

    Seal the back glass to the frame

    2 min

    Lower the back glass into place and press firmly along all edges to seat the adhesive thoroughly.

20. 20

    Reinstall the bottom pentalobe screws

    2 min

    Thread and tighten the two P2 Pentalobe screws next to the USB-C port to finish reassembly.